Fujitsu ETERNUS DX100 S3 - Key Management; Setup Key Management Machine Name

Chapter 1 System Management
1.11 Key Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
166
1.11 Key Management
This section describes key management.
In this section, the SED authentication key is referred to as "key".
Key management provides the following functions:
• Setup Key Management Machine Name
• Add Key Server
• Delete Key Server
• Modify Key Server
• Create Key Group
• Delete Key Group
• Modify Key Group
• Update SED Authentication Key
• Import SSL/KMIP Certificate
1.11.1 Setup Key Management Machine Name
This function specifies the name of the key management device (Key Management Machine).
The key management device name is used for the device that is to be used to connect to the key server.
For details on the parameters for this function, refer to "A.1.10.1 Setup Key Management Machine Name"
(page 751).
The procedure to set the key management device name is as follows:
Procedure
1 Click [Setup Key Machine Name] in [Action].
The ETERNUS DX60 S3 does not support the key management functions.
The key management device name cannot be specified when a common key (*1) is not registered. Refer to
"1.4.7 Register SED Authentication Key" (page 47)
for details.
*1: The common key for SEDs that are managed in the ETERNUS DX S3 series.