Fujitsu ETERNUS DX100 S3 - Page 133

Chapter 1 System Management
1.8 Network Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
133
2 Specify the parameters.
The main setting items are as follows.
● Syslog Server
• Send Log
• Domain Name / IP Address
• Port No.
• LAN Port
3 Click the [Set] button.
 A confirmation screen appears.
4 Click the [OK] button.
 Setting of the Syslog starts.
5 Click the [Done] button to return to the [Network] screen.
End of procedure
An error screen appears if the specified IP address of the Syslog server conflicts with the internal IP
address of the ETERNUS DX. If this occurs, check the parameter settings.
Up to two Syslog servers can be configured. When configuring a second Syslog server, specify the
required parameters in "Syslog Server2".