Chapter 3 Volume Management
3.9 Start RAID Migration
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
307
2 Select "RAID Group / Thin Provisioning Pool / Flexible Tier Pool" for "Migration Destination".
Set the volume information after migration, select the destination RAID group, the TPP, or
the FTRP.
The main setting items are as follows.
● Setting Volume
• Volume Capacity
• FTSP Priority
• Encryption
• Allocation (not displayed for the ETERNUS DX60 S3)
• Start Optimizing TPV/FTV Capacity after migration
• Data Integrity (not displayed for the ETERNUS DX60 S3)
● Select Migration Destination
• Select Migration Destination
• If the migration source is an ODX Buffer volume, select "RAID Group / Thin Provisioning Pool /
Flexible Tier Pool" for "Migration Destination".
• If an error screen appears under the following conditions, check the parameter settings.
- The "Volume Capacity" is not entered
- "Volume Capacity" does not satisfy the input conditions
- "Enable" is selected for "Start Optimizing TPV/FTV Capacity after migration" when capacity
optimization is being performed in the migration source volume
- "Enable" is selected for "Start Optimizing TPV/FTV Capacity after migration" when the migration
source volume is an ODX Buffer volume
To Next Page
Loading...
