Chapter 1 System Management
1.4 System Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
38
The procedure to set the Box ID is as follows:
1 Click [Change Box ID] in [Action].
2 The current Box ID setting appears. To change the value, enter a new Box ID.
The main setting item is as follows.
● Change Box ID
• Box ID
3 Click the [Set] button.
A confirmation screen appears.
4 Click the [OK] button.
The specified Box ID is registered.
5 Click the [Done] button to return to the [System Settings] screen.
If an error screen appears under the following conditions, check the parameter settings.
• A Box ID is not input
• The entered value of a Box ID contains a character other than alphabetic characters (upper case),
numeric characters, hash key characters (#), or spaces
If the Box ID entered is less than 40 characters, a "#" hash key character is appended to the Box ID for
each character short. Then, the 40-digit Box ID is registered in the ETERNUS DX.
To Next Page
Loading...
