Chapter 4 Connectivity Management
4.2 Host Group Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
383
■ When registering a host by manually specifying the host
(1) Click the [Manual Input] tab.
(2) Click the [Add] button.
The [Add SAS Host] screen appears.
(3) Manually specify the SAS address of the host that is to be registered.
The main setting item is as follows.
● Host Setting
• SAS Address
If an error screen appears under the following conditions, check the parameter settings.
• The "SAS Address" is not entered
• The "SAS Address" does not satisfy the input conditions
To Next Page
Loading...
