Chapter 4 Connectivity Management
4.2 Host Group Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
388
3 Add or delete a host in a host group in the following procedures.
■ When adding or deleting a host by selecting from the host list
(1) Click the [Registered And Now Connected] tab.
(2) Add or delete hosts.
The main setting item is as follows.
● Host Group Setting
• Checkbox to select a host
Filter setting
• The range of LUNs that can be recognized from the host are determined by the "LUN Addressing"
settings and the "LUN Expand Mode (Peripheral Device Addressing)" settings for the host
response. Before changing a host response, check the LUN setting state. If LUNs that are LUN#256
onward are used, the recognizable LUN setting cannot be changed to a "256 LUN" host response.
Refer to "Host responses and recognizable LUNs" (page 818)
for details.
• When hosts are to be added in an existing host group and the relevant host already belongs to
another host group, the host response setting is also changed for that host group. If a LUN group
belongs to a host affinity setting for another host group and this LUN group uses LUNs from
LUN#256 onward, the host response setting cannot be changed to "256 LUN".
Filter Description
WWN
Input the WWN that is to be displayed.
FC hosts matching or partially matching the input WWN are displayed.
When not using the WWN for filtering, leave this item blank.
Other Host Group
Input the other host group name that is to be displayed.
FC hosts which belong to any host groups that match or partially match the entered
name are displayed.
When not using the host group name for filtering, leave this item blank.
Host Response
Select the host response that is to be displayed.
Any FC hosts that are allocated to the selected host response are displayed.
To Next Page
Loading...
