Fujitsu ETERNUS DX100 S3 - Page 437

Chapter 4 Connectivity Management
4.3 CA Port Group Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
437
2 Specify the name of the port group to be created, select all the ports to be registered in the
port group.
The main setting items are as follows.
● CA Port Group Setting
• Name
• Checkbox to select ports
3 Click the [Create] button.
 A confirmation screen appears.
4 Click the [OK] button.
 Registration of the FCoE port group starts.
5 Click the [Done] button to return to the [CA Port Group] screen.
End of procedure
If an error screen appears under the following conditions, check the parameter settings.
• The "Name" is not entered
• The "Name" does not satisfy the input conditions
• The "Name" overlaps with an existing port group name
(port group names cannot overlap with any other port group names, irrespective of the CA types.)
• The total number of port groups has exceeded the maximum number for the ETERNUS DX
• Nine or more ports are registered in the port group or no ports are registered in the port group
• Ports with the affinity mode enabled (On) and disabled (Off) exist together