Chapter 4 Connectivity Management
4.3 CA Port Group Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
444
The main setting items are as follows.
● Port Settings
• Port
• Connection
• Set Loop ID
• Loop ID
• Transfer Rate
• WWN (Port Name)
• WWN (Node Name)
3 Click the [Modify] button.
A confirmation screen appears.
4 Click the [OK] button.
Modification of the FC port parameters starts.
5 Click the [Done] button to return to the [FC Port] screen.
■ Copying FC Port Parameters
The procedure to copy FC port parameters is as follows:
1 Select which FC ports to set the parameters for (multiple selections must be made) and click
[Configure FC Port] in [Action].
If some parameters do not satisfy the input conditions, an error screen appears. If this occurs, check
the parameter settings.
If the Loop ID is changed while a server is operating, reboot the server immediately. If the server is
operated without being rebooted, a warning message may appear or a system failure may occur.
Multiple selections can be made from FC ports that have the same "Type" and "Port Mode".
To Next Page
Loading...
