Chapter 4 Connectivity Management
4.7 Host-LU QoS Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
481
■ Enabling QoS mode
The procedure to enable the QoS mode is as follows:
1 Click [Enable QoS] in [Action].
A confirmation screen appears.
2 Click the [OK] button.
Enabling of QoS starts.
3 Click the [Done] button to return to the [Host-LU QoS] screen.
■ Disabling QoS mode
The procedure to disable the QoS mode is as follows:
1 Click [Disable QoS] in [Action].
A confirmation screen appears.
2 Click the [OK] button.
Disabling of QoS starts.
If the QoS mode has already been enabled, [Enable QoS] cannot be clicked.
If the QoS mode has already been disabled, [Disable QoS] cannot be clicked.
To Next Page
Loading...
