Fujitsu ETERNUS DX100 S3 - Page 549

Chapter 5 RAID Group Management
5.7 Assign Eco-mode Schedule (RAID Group)
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
549
For details on the parameters for this function, refer to "A.5.6 Assign Eco-mode Schedule (RAID Group)" (page
920).
For the factory default settings for this function, refer to "Appendix B Assign Eco-mode Schedule (RAID Group)"
(page 1005).
The procedure to set Eco-mode schedule for the RAID group is as follows:
Procedure
1 Select the RAID group to assign the Eco-mode schedule (multiple selections can be made)
to and click [Assign Eco-mode] in [Action].
2 Select the Eco-mode schedule that is to be assigned and select the Eco-mode action.
The main setting items are as follows.
● Eco-mode Schedule Setting
• Eco-mode Schedule
• Eco-mode Action
• Before applying Eco-mode for RAID groups, use the procedure in "1.6.1 Modify Eco-mode General Setting"
(page 75) to enable the Eco-mode setting for the ETERNUS DX S3 series.
• Set the Eco-mode schedule using the procedure in "1.6.4 Modify Eco-mode Schedule" (page 80)
.
• When selecting multiple RAID groups as the target of the Eco-mode, the same Eco-mode schedule can be
specified for all the selected RAID groups.
• RAID groups that configure a WSV can be checked in the [Volume Detail] screen. Refer to "Volume Details
(Used RAID Group)" in "ETERNUS Web GUI User’s Guide (Operation)" for details.
• To use Eco-mode for RAID groups registered in Thin Provisioning Pools, assign the Eco-mode schedule to
the Thin Provisioning Pools. Refer to "6.10 Assign Eco-mode Schedule (Thin Provisioning Pool)" (page
584) for details.
• Note that Eco-mode cannot be set to RAID groups registered in the FTSP.