Fujitsu ETERNUS DX100 S3 - Page 643

Chapter 7 Advanced Copy Management
7.8 REC Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
643
The main setting items are as follows.
● REC Buffer Setting List
• Usage
• Remote Box ID
• Size
• Forwarding Interval
• Monitoring Time
• HALT Wait Timer
3 Click the [Set] button
 A confirmation screen appears.
4 Click the [OK] button.
 The REC Buffer settings starts.
5 Click the [Done] button to return to the [REC Buffer] screen.
End of procedure
If an error screen appears under the following conditions, check the parameter settings.
• The total size of REC Buffers is larger than the maximum capacity for each model
• The same remote Box ID has been selected both for "Send " and for "Receive" as its usage
• The usage of an REC Buffer is "Send" or "Receive", and its path to the remote Box ID has been
deleted
• An REC Buffer, which has already been deleted ("???" is displayed in the "Remote Box ID" field), still
exists
• The usage of an REC Buffer to which an REC Disk Buffer has already been assigned is changed to
"Receive"
• When the setting contents of the REC Buffer has not been changed
• The remote Box ID cannot be changed. To change the remote Box ID, first delete the corresponding
group. Then, click [Modify REC Buffer] again to specify a new remote Box ID and other information
in the corresponding group.
• To change "I/O Priority Mode", "Immediate HALT Mode", or "High Bandwidth Mode", click
"Advanced Setting".