Appendix A Parameter List
A.1 System Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
715
A.1.7.7 Setup SNMP Agent Community
For details about this function, refer to "1.8.7 Setup SNMP Agent Community" (page 120).
For the factory default settings for this function, refer to "Appendix B Setup SNMP Agent Community" (page
981).
● Setup SNMP Agent Community
• Community Name
• View Name
• Allowed SNMP Manager List
Description Input the community name to be used when accessing a MIB or sending a trap.
The community name which has already been used cannot be entered.
Input condition/
Display contents
• Up to 32 alphanumeric characters and symbols ("! (exclamation mark)", "# (hash
mark)", "& (ampersand)", "_ (underscore)", "+ (plus)", "- (hyphen)", "* (asterisk)" and
"/ (slash)")
• Spaces
Description Select the view name to specify the MIB access range for the community.
A "blank" means accessing the MIB is not allowed.
Input condition/
Display contents
• ViewALL
• View-mib2
• View-exmib
• The view name, which has been registered using the [Setup SNMP Agent MIB Access
View] function
If "ViewALL", "View-mib2", or "View-exmib" is deleted with the procedure in "1.8.5 Setup SNMP Agent MIB Access
View" (page 115), the deleted options are not displayed in "View Name".
Description Select the IP address of the SNMP Manager which is allowed to access in the community.
Only the selected SNMP Manager is allowed to access.
However, if the Allowed SNMP Agent Manager List has been left blank, all of the SNMP
Agent Managers (*1) are allowed to access.
*1: Not only the SNMP Agent Manager which has been registered in "1.8.4 Setup
SNMP Manager" (page 113), but also the other SNMP Agent Managers are allowed
to access.
Input condition/
Display contents
Checkbox
• Selected
• Cleared
To Next Page
Loading...
