Appendix A Parameter List
A.4 Connectivity Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
831
• Name
• Host Response
• IP Version
Description Specify the iSCSI host name.
Input condition/
Display contents
Up to 16 alphanumeric characters, symbols (except "," (comma) and "?"), and spaces
Description Select a host response to be assigned to an iSCSI host.
The host response list created in the ETERNUS DX is displayed.
Input condition/
Display contents
• Solaris MPxIO
• HP-UX
• AIX
• AIX VxVM
• VS850/SVC
• BS2000
• Host responses created in the ETERNUS DX
• Default
Description Select the IP version of the iSCSI host.
Input condition/
Display contents
• IPv4
• IPv6
To register an iSCSI host without using an IP address, perform IP version selection as follows:
• Select "IPv4" when the IP address format of the iSCSI host is IPv4 (when using an IPv4 host)
• Select "IPv6" when the IP address format of the iSCSI host is IPv6 (when using an IPv6 host)
• If the IP address format of the iSCSI host cannot be checked (when either an IPv4 host or an IPv6 host is used),
register two hosts. Select "IPv4" for one host, and select "IPv6" for the other host. Specify the same iSCSI name,
CHAP user ID, and CHAP password for each host.
To Next Page
Loading...
