Fujitsu ETERNUS DX100 S3 - Page 840

Appendix A Parameter List
A.4 Connectivity Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
840
• Checkbox to select a port
A.4.3.3 Create SAS Port Group
For details about this function, refer to "4.3.3 Create SAS Port Group" (page 433).
● CA Port Group Setting
• Name
• Checkbox to select a port
Description Select the checkbox of the iSCSI port to be registered in an iSCSI port group.
Input condition/
Display contents
Checkbox
• Selected
• Cleared
• When a port in the affinity mode enabled (On) is selected, ports in the affinity mode disabled (Off) cannot be
selected.
• When a port in the affinity mode disable (Off) is selected, ports in the affinity mode enable (On) cannot be
selected.
• Up to eight ports can be selected.
Description Specify the port group name.
An existing port group name cannot be used.
Input condition/
Display contents
• Up to 16 alphanumeric characters and symbols (except "," (comma) and "?")
• Spaces
Description Select the checkbox of the SAS port to be registered in a SAS port group.
Input condition/
Display contents
Checkbox
• Selected
• Cleared
• When a port in the affinity mode enabled (On) is selected, ports in the affinity mode disabled (Off) cannot be
selected.
• When a port in the affinity mode disable (Off) is selected, ports in the affinity mode enable (On) cannot be
selected.
• Up to eight ports can be selected.