Appendix A Parameter List
A.4 Connectivity Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
843
• Set Loop ID
• Loop ID
• Transfer Rate
Input condition/
Display contents
• Fabric
A connection type that enables simultaneous communication among multiple nodes
through a Fibre Channel switch.
• FC-AL
A connection type that connects multiple nodes in a loop.
This connection type is used for a direct connection when the transfer rate is 8Gbit/s
or less.
Select "Fabric" for a direct connection when "Transfer Rate" is "16 Gbit/s". If direct connection is used for some of the
remote Fibre Channel cards, FC switches may be required. For details, refer to the Fibre Channel card specifications.
Description When the connection type is "FC-AL", select "Manual" or "Automatic" as the specification
method for the Loop ID.
"Loop ID" is an identification number of a node in a loop.
Input condition/
Display contents
• Manual
• Automatic
Description When "Set Loop ID" is "Manual", input the Loop ID.
When "Set Loop ID" is "Automatic", select "Ascending" or "Descending".
The Loop ID must have a value that is different from the values of all the ports.
Input condition/
Display contents
• When "Set Loop ID" is "Manual"
0x0 - 0x7D
• When "Set Loop ID" is "Automatic"
- Ascending
- Descending
Description Select the transfer speed for the target port.
The available transfer rate varies according to the selected port type and connection
topology.
Input condition/
Display contents
• Auto-negotiation
• 4 Gbit/s
• 8 Gbit/s
• 16 Gbit/s
Note that "16 Gbit/s" cannot be selected in the following conditions:
- SFP type is "SFP+(SMF)" or "SFP+(MMF)"
- The connection type is "FC-AL"
• Select "Auto-negotiation", "4 Gbit/s", "8 Gbit/s", or "16 Gbit/s" for the transfer rate.
• "Auto-negotiation" is selected for the transfer rate when the transfer rate is "16 Gbit/s" and the connection type
is changed from "Fabric" to "FC-AL".
To Next Page
Loading...
