Appendix A Parameter List
A.4 Connectivity Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
866
• Transfer Rate (Gbit/s)
• Set VLAN ID
• VLAN ID
• Set Fabric Name
• Fabric Name
Description Set the transfer speed of the target port.
Input condition/
Display contents
10 Gbit/s
Description Specify "Automatic" to enable the automatic setting for the VLAN ID of the target port.
Specify "Fixed" to enable the fixed setting.
When "Automatic" is specified, VLAN ID is automatically obtained and no need to specify
the VLAN ID.
When "Fixed" is specified, input the VLAN ID.
Input condition/
Display contents
• Automatic
• Fixed
Description Input the VLAN ID for the target port.
Make sure to set the same value for the VLAN ID as the VLAN ID of the FCoE switch that is
to be connected to.
Input condition/
Display contents
0 - 4095
Description Specify "Automatic" to enable the automatic setting for the fabric name of the target
port. Specify "Fixed" to enable the fixed setting.
When "Automatic" is specified, the fabric name of the connected FCoE switch is
automatically obtained and does not need to be specified.
When "Fixed" is specified, input the fabric name.
"Automatic" should be set for normal operation. When "Fixed" is specified, connection to
any switch other than the specified FCoE switch cannot be performed.
Input condition/
Display contents
• Automatic
• Fixed
Description Input the fabric name (WWN of FCoE) of the target port.
Input condition/
Display contents
WWN of FCoE (16-digit hexadecimal)
To Next Page
Loading...
