Fujitsu ETERNUS DX100 S3 - Page 995

Appendix B Factory Default List
B.3 Connectivity Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
995
■ Modify FC Port Parameters (when the port mode is "Initiator")
■ Modify iSCSI Port Parameters (when the port mode is "CA")
Screen Setting item Default value
Port Settings Connection FC-AL
Set Loop ID Manual
Loop ID
• When "Set Loop ID" is "Manual"
0x0
• When "Set Loop ID" is "Automatic"
Ascending
Transfer Rate Auto-negotiation
Frame Size 2048 (bytes)
WWN (Port Name) WWPN of the ETERNUS DX
WWN (Node Name) WWNN of the ETERNUS DX
Screen Setting item Default value
iSCSI Settings iSCSI Name iqn.2000-09.com.fujitsu:storage-system.eternus-
xxxx:00yyyyyy (*1)
TCP/IP Settings IP Version IPv4
IP Address 192.168.xxx.xxx
Subnet Mask 255.255.255.0
Gateway Not specified
IPv6 Link Local Address Address that is obtained from the WWN of the
ETERNUS DX
IPv6 Connect IP Address Not specified
IPv6 Gateway Not specified
TCP Port No. 3260
TCP Window Scale 2
iSNS Server Disable
iSNS Server Port No. 3205
VLAN ID
• Disable
• When the "Enable" checkbox is selected
0
Jumbo Frame Disable
Security Setting CHAP OFF
Header Digest OFF
Data Digest OFF
General Settings Reset Scope I_T_L
Release Reservation if Chip is
Reset
Disable
CmdSN Count Unlimited