ATTENTION
● Moving the feed mode switch during a scan causes an error.
● If the feed mode switch is in Manual Single Mode, overlapped documents cannot be detected by the
ultrasonic sensor.
HINT
The scanner will wait for the next document to be loaded until the time specified for [Timeout seconds] in
the [Manual Feeding] screen on the touch screen, even if there is no document in the ADF paper chute
(feeder).
The [Manual Feeding] screen can be displayed in the following procedure:
→ [Scanner Settings] → [Paper Source/Feeding] → [Manual Feeding]
When using the Software Operation Panel, refer to Waiting Time in Manual Feeding [Manual Feeding]
(page 294).
Various Ways to Scan
100
To Next Page
Loading...
