Connecting to a Wireless Access Point by Pressing the WPS Button
1 In the screen for selecting a configuration method, select [Use WPS] and press the [Next] button.
2 Check the setting items and the order of them, and then press the [Start] button.
The screen for selecting the method with the WPS function is displayed.
3 Select [Push-Button] and press the [Next] button.
The operation guidance screen is displayed.
4 Press the WPS button on the wireless access point to have it ready to connect to the scanner.
For details about WPS, refer to the manual of your wireless access point.
5 Go back to the touch screen and press the [Next] button within two minutes.
When the connecting process is complete, the connection result is displayed.
6 Press the [Next] button.
Specify the following items:
Refer to step 4 in When Connecting the Scanner via Wi-Fi (page 34).
Scanner Setup
38
To Next Page
Loading...
