Settings Related to Scanner Maintenance and Inspection Cycle
[Maintenance and Inspection Cycle]
Specify the maintenance and inspection cycle for the scanner that is performed by a service engineer.
If the specified period has passed after the last maintenance and inspection date, the touch screen displays a
notification on
when you receive a [Maintenance] message.
For regular maintenance and inspection on the scanner by a service engineer, contact the distributor/dealer where
you purchased this product. Or, make an inquiry by referring to the contact information at the Contact for Inquiries
section in Safety Precautions bundled with this product.
1 Start up the Software Operation Panel.
For details, refer to Starting Up the Software Operation Panel (page 241).
2 From the list on the left, select [Device Setting 2] → [Maintenance and Inspection Cycle].
3 Select [Enable] to receive a message on the touch screen when it gets closer to the time for
maintenance.
The factory default setting is [Disable].
4 Select the cycle to receive a message.
The factory default setting is "12 months".
Scanner Settings (Software Operation Panel)
302
To Next Page
Loading...
