Scanner Cleaning Cycle [Cleaning Cycle]
Specify the cleaning cycle for the scanner inside.
The background color of the [After cleaning] counter in [Device Setting] changes to yellow when the counter
reaches the specified value for this item.
You can also display a cleaning instruction message that is described in Messages for Cleaning or Replacing
Consumables (page 262).
1 Start up the Software Operation Panel.
For details, refer to Starting Up the Software Operation Panel (page 241).
2 From the list on the left, select [Device Setting 2] → [Cleaning Cycle].
3 Specify a value for the cleaning cycle.
The value can range from 1,000 to 255,000 sheets (in increments of 1,000).
The factory default setting is "5".
4 Specify whether or not to display the cleaning instruction message.
The [Show cleaning instructions] check box is cleared for the factory default settings.
Scanner Settings (Software Operation Panel)
263
To Next Page
Loading...
