Fujitsu fi-7300NX User Manual

Using an Image Scanning Application on the Computer
This section explains about the basic flow of performing a scan using an image scanning application on the
computer.
In this case, a scanner driver and an image scanning application that supports the scanner driver must be installed
on the computer.
The following scanner driver and image scanning applications are bundled with the scanner:
● Scanner driver
- PaperStream IP driver
● Image scanning application
- PaperStream Capture
- ScanSnap Manager for fi Series
HINT
For details about the scanner driver and image scanning applications, refer to Overview of the Bundled Software
(page 50).
Scanning procedures, operations, and scan setting items slightly vary depending on the image scanning application
and the scanner driver.
For details, refer to the help for the image scanning application and the scanner driver.
1 Turn on the scanner.
For details, refer to How to Turn the Power ON (page 55).
2 Load a document in the ADF paper chute (feeder).
Load the document face-down in the ADF paper chute (feeder).
For details, refer to How to Load Documents (page 78).
3 Start an image scanning application.
4 Select a scanner driver to be used for scanning.
For some image scanning applications, selection of a scanner driver may not be needed.
How to Perform a Basic Scan
68

Fujitsu fi-7300NX Specifications

General

Brand	Fujitsu
Model	fi-7300NX
Category	Scanner
Language	English