Connecting to a Wireless Access Point by Entering the PIN for WPS
1 In the screen for selecting a configuration method, select [Use WPS] and press the [Next] button.
2 Check the setting items and the order of them, and then press the [Start] button.
The screen for selecting the method with the WPS function is displayed.
3 Select [PIN] and press the [Next] button.
The operation guidance screen is displayed.
4 Note down the PIN that is displayed in the screen.
5 On the computer, open the setting window for WPS of the wireless access point.
For details about WPS, refer to the manual of your wireless access point.
6 Specify the PIN which you noted down to have it ready to connect to the scanner.
7 Go back to the touch screen and press the [Next] button within two minutes.
When the connecting process is complete, the connection result is displayed.
8 Press the [Next] button.
Specify the following items:
Refer to step 4 in When Connecting the Scanner via Wi-Fi (page 34).
Scanner Setup
39
To Next Page
Loading...
