EasyManuals Logo

Fujitsu fi-7300NX User Manual

Fujitsu fi-7300NX
311 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #228 background imageLoading...
Page #228 background image
- When a piece of paper is attached on a document, the length and position of the paper can be
memorized, and set to ignore overlapping of documents.
Set it in [Intelligent Multifeed Detection].
Check Length
Detects overlapped documents according to the difference in length.
Select this to scan documents of the same length.
Note that overlapped documents cannot be detected accurately when a mixed batch of different
lengths are scanned.
Check Overlapping and Length
Detects overlapped documents by the combination of [Check Overlapping (Ultrasonic)] and
[Check Length].
When this is selected, you can specify the following two options:
- Specify an area to detect overlapped documents by the length from the leading edge of the
document in the feeding direction.
Set it in [Multifeed Detection Area].
- When a piece of paper is attached on a document, the length and position of the paper can be
memorized, and set to ignore overlapping of documents.
Set it in [Intelligent Multifeed Detection].
Note that overlapped documents cannot be detected accurately when a mixed batch of different
lengths are scanned.
Threshold (Length)
Specify the difference in length of documents to be detected as overlapped documents.
Overlapped documents are detected when the the difference in length of documents is longer than
the specified value.
Specify this item when [Check Length] or [Check Overlapping and Length] is selected for
[Detection Method].
Any length under the specified value is tolerated as a slight error and not detected as overlapped
documents.
10 mm or less is not detected
This is the factory default setting.
15 mm or less is not detected
20 mm or less is not detected
ATTENTION
To scan documents with different lengths, select [Check Overlapping (Ultrasonic)].
When an attachment such as a sticky note, receipt, or photo is attached on the document, the
attachment part of the document may be detected as overlapping of documents if
[Check Overlapping (Ultrasonic)] is selected. In that case, select [Check Length].
Otherwise, detect overlapping of documents by specifying an area on the document that does not
include an area attached with paper in order to ignore the overlapping of documents for that area.
Scanner Settings (Touch Screen)
228

Table of Contents

Other manuals for Fujitsu fi-7300NX

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fujitsu fi-7300NX and is the answer not in the manual?

Fujitsu fi-7300NX Specifications

General IconGeneral
BrandFujitsu
Modelfi-7300NX
CategoryScanner
LanguageEnglish

Related product manuals