Magnification
Magnification (%)
Specify the magnification level for the feed direction.
The specified value can range from -3.1 to +3.1% (in increments of 0.1).
The factory default setting is "0.0".
ATTENTION
Normally, you should not have to modify anything as the factory default settings already use adjusted
values.
Image Quality Mode
To obtain an image quality that is close to the image quality for scanning with fi-6130Z, set the image
quality mode.
● Disable
This is the factory default setting.
● fi-6130Z
Scanner Settings (Touch Screen)
237
To Next Page
Loading...
