Setting Item Description
Multifeed Configure the settings to detect overlapped documents during a
scan.
Page Edge Filler (ADF) Configure the settings to fill in the shadow or streaks around
the edge of the scanned image.
Dropout color You can exclude a color from being scanned by selecting either
red, green, or blue (three primary colors).
Pre-Pick Enable this to shorten the scanning time when scanning
continuously.
Document check area specification for
Multifeed Detection
Specify an area to detect overlapped documents.
Intelligent Multifeed Function Configure the setting to automatically ignore certain patterns of
overlapped documents when the setting to detect overlapped
documents is enabled.
Number of paper feeding retries Specify the number of feeding retries when a document is not
fed from the ADF paper chute (feeder).
Cleaning Cycle Specify the cleaning cycle for the scanner inside.
Life Counter Alarm Setting Specify the replacement cycle for the consumables.
Vertical Streak Detection You can configure the settings for detecting dirt on the glass.
Vertical Streak Sensitivity Specify the sensitivity level to detect vertical streaks (dirt on the
glass) when [Enable] is selected for [Vertical Streak Detection].
Pick Speed You can specify the timing of when document feeding is started.
AutoCrop Boundary When the scanner is set to detect the paper size automatically,
specify whether or not to optimize (round up/down) the
fractional part of the scanned image.
Manual Feeding Configure the settings when manually loading and scanning
one sheet at a time.
Power SW Control Specify whether or not to turn on/off the scanner by pressing
the [Power] button on the scanner.
Paper Protection Configure the setting to detect feeding errors.
Paper Protection Sensitivity Specify the sensitivity level for detecting feeding errors when
the paper protection function is enabled.
Maintenance and Inspection Cycle Specify the maintenance and inspection cycle for the scanner
that is performed by a service engineer.
High Altitude Mode Enable this mode to use the scanner at an altitude of 2,000 m
or higher.
Scanner Settings (Software Operation Panel)
257
To Next Page
Loading...
Need help?
General
