After cleaning
Total number of sheets scanned after cleaning
Brake Roller
Number of sheets scanned after the brake roller is replaced
Pick Roller
Displays the number of sheets scanned after the pick roller is replaced.
The factory default setting for each counter is "0".
ATTENTION
If you turned off the scanner by unplugging the power cable, or selected [Disable power switch], the
number of scanned sheets may not be counted in [Total Count].
For details about disabling the power switch, refer to Method of Turning the Scanner ON/OFF
[Power SW Control] (page 297).
Scanner Settings (Software Operation Panel)
260
To Next Page
Loading...
