Fujitsu fi-7300NX

3 Adjust the level of offset/vertical magnification as needed.
Offset Setting
Unit
Select [ADF (front)] or [ADF (back)] as the unit for an offset adjustment.
The factory default setting is [ADF (front)].
Main
Specify the horizontal (width) offset.
The specified value can range from -2 to +2 mm (in increments of 0.5).
The factory default setting is "0".
Sub
Specify the vertical (length) offset.
The specified value can range from -2 to +2 mm (in increments of 0.5).
The factory default setting is "0".
Scanner Settings (Software Operation Panel)
266