The specified area is filled in white or black, according to the background color.
(1): Top = 0 to 15 mm
(2): Bottom = -7 to 7 mm
(3): Right = 0 to 15 mm
(4): Left = 0 to 15 mm
(in 1 mm increments)
ATTENTION
Note that if the target range of page edge filler is too wide, some characters near the edge may appear
missing.
HINT
● You can change the background color to black or white in the scanner driver.
For details, refer to the help for the scanner driver.
● Depending on the value you specify for the bottom margin of the page edge filler, the page edge filler
function operates as follows:
- 1 to 7 mm
Fills in the specified area with the background color from the bottom edge of the image towards the
inside.
- -1 to -7 mm
Outputs the image without filling in the specified area with the background color from the bottom
edge of the image towards the outside. (Outputs the image with the specified area added when
[Page End Detection] is set in the scanner driver.)
● This setting can also be configured in the scanner driver.
In such a case, the page edge filler of the scanner driver is used on the image which the scanner already
filled in the edges.
Scanner Settings (Software Operation Panel)
269
To Next Page
Loading...
Need help?
General
