Feeding Accuracy & Noise
Stops the scan when the scanner detects a warped document caused by a feeding error, or when the
scanner detects paper jam noise.
ATTENTION
● Note that the paper protection function is to prevent damages to documents, but the protection of all
documents is not guaranteed.
● When you use the paper protection function, make sure to load the documents with their top edges
aligned (especially for a mixed batch of documents with different lengths).
If the top edges are not aligned properly, the scan may stop even when the documents are being fed
correctly.
HINT
● If you scan a wrinkled document, the scan may stop even when the document is being fed correctly.
In that case, the paper protection function can be disabled only for the document on the touch screen.
For details, refer to Disabling the Paper Protection Function (page 110).
● If the paper protection function stops scans frequently, refer to Paper Protection Is Set Off Frequently
(page 203).
● This setting can also be configured in the scanner driver.
When the setting is to prioritize the touch screen setting, the touch screen setting is prioritized over the
Software Operation Panel setting.
Note that even if the touch screen setting is prioritized, the scanner driver setting has the highest
priority.
Scanner Settings (Software Operation Panel)
278
To Next Page
Loading...
Need help?
General
