HINT
● The accuracy of detection for overlapped documents may drop depending on the document type.
Overlapping cannot be detected for the top 30 mm (1.18 in.) of a document in the feeding direction.
● On the [Multifeed Detection Area] screen, you can specify an area not to detect overlapping of documents
within the area described in Fig. 1 in Area Not to Be Perforated (page 84).
The [Multifeed Detection Area] screen can be displayed in the following procedure:
→ [Scanner Settings] → [Paper Source/Feeding] → [Multifeed Detection Area]
When using the Software Operation Panel, refer to Settings Related to the Detection for Overlapped
Documents (Multifeed) (page 283).
How to Load Documents
86
To Next Page
Loading...
