6.2 Names and Functions of Parts
(1) AC power inputs
Connect the power cables to these points. Both AC power cords must be plugged into the same
power grid / circuit.
(2) PCI slots (option)
PCI slots conform to PCI local bus specifications (Rev. 2.1).
64-bit bus, 33MHz (5.0 V) and 33/66MHz (3.3V) are supported.
Both short cards (17.46 cm, 6.87 in.) and long cards (31.19 cm, 12.3 in.) are supported.
(3) Power control switch (label : PC)
8-pin DIN for power control
(4) UPS port (label : UPS)
Dsub-9 pin for connecting the signal cable of an uninterruptible power supply
(5) RCI port (label : RCI)
RJ11 connector for connecting the RCI cable and terminator (provided with the server unit)
(6), (7) Serial ports (label : SERIAL A/B)
Dsub-25 pin port for connecting a console terminal when performing maintenance on the server unit
using the RS-232C interface
(8) Keyboard port (label : KB)
8-pin DIN port for connecting a keyboard cable
(9) 100Base-TX ports (label : LAN)
RJ45 connector automatically recognizes 10Mbps/100Mbps.RJ45 connector (10) is available when
the system expansion board is installed.
95
To Next Page
Loading...
