CHAPTER 11 Internal I/O Units
6 Confirm the transfer rate (checking the glm.conf settings)
Use the "prtconf -v" command to check the value of the "target5-sync-speed" setting.
In the following example this is: 0x4e20(KB/sec) = 20000(KB/sec) = 20(MB/sec), confirming that the DDS4
is working at fast20 (Ultra SCSI) speed.
(A lower value may indicate incorrect settings.)
#prtconf -v
System Configuration: Sun Microsystems sun4us
Memory size: 9216 Megabytes
System Peripherals (Software Nodes):
FJSV,GPUS
System properties:
name <relative-addressing> length <4>
value <0x00000001>.
...
name <target5-sync-speed> length <4>
value <0x00004e20>. ←Check this value!
...
202
To Next Page
Loading...
