Fujitsu PRIMERGY RX200 S2 User Manual

106
Chapter 3 OS Installation Using ServerStart
Settings values in wizards
 Setting items in wizards are set to the values set on the first server. For installation on subse-
quent servers, you must change the following items in the "OS installation wizard". For other
items, change the settings as necessary. You do not need to start up wizards where no settings
will be changed.
 If the settings for the first server are not reflected to wizards, perform the procedures from
copying the floppy disk over again.
3.5.3 Installation in Preconfiguration Mode
Edit the configuration file and perform installation in preconfiguration mode.
If ServerStart is not installed in the client computer where the preconfiguration mode is executed, refer
to "2.4 Preparation for Using ServerStart on a Client Computer" (
pg.49) to install ServerStart. If a
different version of ServerStart has been installed, uninstall it and install the proper version. For details
on how to uninstall ServerStart, refer to "2.4.2 Uninstalling ServerStart" (
pg.51).
 ServerStart starts up when it is installed. However, be sure to follow these installation procedures.
Performing the procedure in "3.2.1 Starting Up the Preconfiguration Mode" (pg.71) deletes the
contents of the ServerStart floppy disk, making the disk unavailable for installation on multiple servers.
1 Start up ServerStart.
If ServerStart has already been started, it is not necessary to restart it. If it has not, start it up
according to the following procedures.
When the CD has been copiedon Windows 2000 Professional/Windows XP
Professional
1. Click [Start] → [Programs] → [Fujitsu ServerStart] → [ServerStart].
ServerStart starts up and the [Welcome to ServerStart] window appears.
When Windows NT is used, or if the CD has not been copied
1. Insert the ServerStart CD-ROM into the client computer's CD-ROM drive.
ServerStart starts up and the [Welcome to ServerStart] window appears.
2 Select the OS to install.
The preconfiguration mode starts up.
table: Settings to be Changed for Installation on Subsequent Servers
Window
name
Setting item name Remarks
User
Information
Computer name The setting must be changed when the second
and subsequent servers are on the same
network as the first server.
Product ID/CD key The setting must be changed.
Network
Protocol
IP address The setting must be changed when the second
and subsequent servers are on the same
network as the first server.

Fujitsu PRIMERGY RX200 S2 Specifications

General

Chipset	Intel 5000P
Network	Dual Gigabit Ethernet
Operating System Support	Windows Server, Linux
Processor	Intel Xeon processors
Memory Slots	8 x DIMM
RAID Support	RAID 0, 1
Power Supply	Redundant power supply
Form Factor	1U rack server