76
Chapter 3 OS Installation Using ServerStart
3.2.4 Starting OS Installation
Install the OS to the server using the created configuration file.
During installation, do not use the mouse or keyboard unless it is necessary for installation operations.
Otherwise, installation may fail.
ī When you do not configure an array but will perform installation to an array-configured server, remove
the array before starting up ServerStart. For the procedure for deleting an array, refer to "8.3.7 RAID
Properties Submenu" (īpg.242).
1 Turn on the server and insert the ServerStart CD-ROM immediately.
A message prompting you to insert the ServerStart floppy disk appears.
2 Insert the ServerStart floppy disk containing the created configuration file and
click [OK].
ī Set the ServerStart floppy disk in the write-enabled state. If it is write protected, installation will
fail.
The [Initializing of ServerStart] window appears and unattended installation will be started.
Depending on the hardware configuration, this process may take a few minutes. When the
process is completed, the [ServerStart Unattended Mode] window appears.
To Next Page
Loading...
Need help?
General
