Fujitsu PRIMERGY RX200 S2 User Manual

164
Chapter 7 Installing Internal Options
7.1 Before Installing Internal Options
The following types of internal options can be installed on this server.
 When installing or removing devices, make sure to use the removed screws on the same location and
devices that were last installed or removed. Failure to do so can damage the device.
 The types of installable options described in this manual are subject to change without notice.
• When installing/removing internal options to/from the server, turn off the
server, all peripheral devices, and any other connected devices. Also unplug
all power cables from the server. Failure to do so may cause electric shock
("1.4.3 Turning Off the Server" (pg.32)).
• Do not disassemble the power supply unit. Doing so may cause electric
shock.
• Do not install unauthorized third party internal options. Doing so may cause a
device failure, fire, or electric shock.
• Do not damage or modify internal cables or devices. Doing so may cause a
device failure, fire, or electric shock.
Memory module
Expansion card
Internal hard disk unit
Internal CD-ROM drive unit
Power supply unit
CPU
[Front]

Fujitsu PRIMERGY RX200 S2 Specifications

General

Chipset	Intel 5000P
Network	Dual Gigabit Ethernet
Operating System Support	Windows Server, Linux
Processor	Intel Xeon processors
Memory Slots	8 x DIMM
RAID Support	RAID 0, 1
Power Supply	Redundant power supply
Form Factor	1U rack server