Fujitsu PRIMERGY RX200 S2 User Manual

144
Chapter 5 Operations after OS Installation
■ Starting ServerStart
● For Creation on a Client Computer
When the CD has been copied on Windows 2000 Professional/Windows XP
Professional
1 Click [Start] → [Programs] → [Fujitsu ServerStart] → [ServerStart].
ServerStart starts up and the [Welcome to ServerStart] window appears.
When Windows NT is used, or if the CD has not been copied
1 Insert the ServerStart CD-ROM into the client computer.
ServerStart starts up and the [Welcome to ServerStart] window appears.
● For Creation on the Server
1 Turn on the server and insert the ServerStart CD-ROM immediately.
ServerStart starts up and a message appears prompting you to insert the ServerStart floppy disk.
2 Insert the attached "ServerStart floppy disk" into the server's floppy disk drive.
Then make sure "Removable media" and "A:" are selected and click [Create].
A network setup window for remote installation appears.
 If a configuration file already exists in the ServerStart floppy disk and [OK] is clicked without
clicking [Create], the [ServerStart Unattended Mode] window appears. Make sure to click
[Exit]. The [Welcome to ServerStart] window appears.
If [Start] is clicked in the [ServerStart Unattended Mode] window, the installation of the server
will start and all disk contents will be deleted.

Fujitsu PRIMERGY RX200 S2 Specifications

General

Chipset	Intel 5000P
Network	Dual Gigabit Ethernet
Operating System Support	Windows Server, Linux
Processor	Intel Xeon processors
Memory Slots	8 x DIMM
RAID Support	RAID 0, 1
Power Supply	Redundant power supply
Form Factor	1U rack server