02–TX150S2–132 July 2004 U41057-J19-Z146-1-76
Replacing the IDTEMP combo Removal/installation routines
Ê Push the holder in direction of the arrow.
Ê Take out the holder carefully.
Ê Remove the green plastic part from the connector on the IDTEMP combo.
Ê Disconnect the I
2
C bus cable from the connector.
Notice the leading of the cable.
Ê Pull the IDTEMP combo out of its holder.
Installing is done in reverse order.
The green plastic part is the colored marking
of a ’touch point’.
!
To Next Page
Loading...
