U41057-J19-Z146-1-76 July 2004 02–TX150S2–89
Removal/installation routines Hard disk subsystem
© Siemens Nixdorf Informationssysteme AG 1995 Pfad: P:\02-systemeinheiten\TX150S2\TX150S2-e\TX150S2-e.k04
Changing the hard disk drive in the hard disk carrier
Please note that the hard disk drives which can be ordered for the server
are supplied already mounted in hard disk carriers. Only under special
circumstances should a hard disk drive need to be changed out of its
carrier.
Make sure that the new hard disk drive has the right interface (SCA or
SATA).
Ê Remove the hard disk module indicated as defective.
Ê Remove the four screws on the sides of the hard disk carrier, two on the right
and two on the left.
Ê Take the hard disk drive out of the hard disk carrier.
Ê Replace the hard disk drive or the hard disk carrier.
Ê Mount the hard disk drive in the hard disk carrier with four screws.
Use always the four delivered screws (round-headed). Every other
screws head form will damage the guiding rails on each side.
Installation is performed in reverse order.
i
!
!
To Next Page
Loading...
Need help?
General