EasyManua.ls Logo

Fujitsu PRIMERGY TX200 S2 - Creating a System Recovery Disk for Windows 2000 Server

Fujitsu PRIMERGY TX200 S2
317 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
144
Chapter 5 Operations after OS Installation
8 When the process is completed, a message appears. Eject the floppy disk
according to the message and put a label on it.
Label Example: "Windows Automated System Recovery Disk: Backup.bkf, Created at 12:00 04/
01/2003"
9 Click [OK] to exit [Backup Utility].
10 Click [Close] to close the [Backup Progress] window.
An automated system recovery set has been created.
Store the automated system recovery set just created in a secure location.
5.2.2 Creating a System Recovery Disk
For Windows 2000 Server
After setting up Windows Server 2000, create a system recovery disk. To do this, you need an unused
formatted floppy disk.
1 Put a label showing "Windows 2000 system recovery disk" onto a floppy disk
and insert it into the floppy disk drive.
2 Click [Start] [Programs] [Accessories] [System Tools] [Backup].
The backup window appears.
3 Click the [Wizard] tab and click [System Recovery Disk].
Create a system recovery disk by following the window instructions.

Table of Contents

Other manuals for Fujitsu PRIMERGY TX200 S2

Related product manuals