Fujitsu PRIMERGY TX200 S2 User Manual

93
PRIMERGY TX200 S2 User’s Guide
3
OS Installation Using ServerStart
● Checking Server Free Space
The following table shows the amount of free space required for each installation resource.
Calculate the total resource size. Check that the remote resource server / PXE server has enough free
space (free space greater than the space required for the resources). When the amount of free space is
insufficient, you must use more remote resource servers.
3.4.3 Preparation of the PXE Server (When the PXE Server
is Used)
When performing remote installation using a PXE server, preparatory procedures, such as installing
ServerStart, are required.
Perform the following procedures to prepare the PXE server.
■ Starting the DHCP Service
Check that the DHCP service is running on the same network.
If the DHCP service function is not installed, perform the following procedures (for Windows Server
2003) to install the DHCP service.
1 Click [Start] → [Control Panel] → [Add or Remove Applications].
table: Free Space Required for Resources
Resource Required free space
ServerStart About 650MB
Windows Server 2003 644MB
Windows 2000 Server 472MB
Windows 2000 Service Pack 4 433MB
Starting the DHCP Service
Installing ServerStart
Checking Services
Setting TFTP
Preparation of Resources

Fujitsu PRIMERGY TX200 S2 Specifications

General

Brand	Fujitsu
Model	PRIMERGY TX200 S2
Category	Server
Language	English