Fujitsu PRIMERGY TX200 S2 - Installing High Reliability Tools

21
PRIMERGY TX200 S2 User’s Guide
1
Overview
1.2.3 Installing High Reliability Tools
You can install all high reliability tools provided with PRIMERGY by specifying them in "Application
Wizard" when the OS is installed with ServerStart.
After manual OS installation, high reliability tools can be installed all at once, just as they are installed
during OS installation with ServerStart.
In each case, the following high reliability tools are installed.
A: Installed in any case
S: Installed if selected
*1: Will not be installed when a RAID controller is not installed
*2: Will not be installed when a LAN card (PG-1852/PG-1862/PG-1882/PG-1892) is not installed
 Linux does not support batch installation with ServerStart.
 ServerView must be configured after installation even when the high reliability tools have been
installed at once with ServerStart. Refer to "Chapter 6 High Reliability Tool" (pg.167).
 RAID Management Tool requires that ServerView have been installed. Be sure to install ServerView.
table: Installation of high reliability tools
High reliability tool Batch installation
RAID Management Tool
Α
* 1
ServerView S
DSNAP S
Intel® PROSet
Α
*2
Broadcom Advanced Control Suite (BACS) A