EasyManua.ls Logo

Fujitsu PRIMERGY TX200 S2 - Page 17

Fujitsu PRIMERGY TX200 S2
317 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
17
PRIMERGY TX200 S2 User’s Guide
1
Overview
Configuration File (SerStartBatch.ini)
A configuration file stores the server setup information configured in ServerStart. To create a
configuration file, use the ServerStart floppy disk supplied with this server. Store only one file on each
floppy disk. Do not set the ServerStart floppy disk to the write-protected state.
You can use any name for the configuration file. However, the file must be installed in the server as
"SerStartBatch.ini". When installing the configuration file, make sure to save it as "SerStartBatch.ini" on
the ServerStart floppy disk.
Start up ServerStart, insert the ServerStart floppy disk containing "SerStartBatch.ini", and click [Start] to
install the server.
Intuitive User Interface
The intuitive user interface allows you to easily set the necessary information.
Main Window
When ServerStart is started, the following window appears. The window and tool bar differ depending
on the mode.

Table of Contents

Other manuals for Fujitsu PRIMERGY TX200 S2

Related product manuals