35
PRIMERGY TX200 S2 User’s Guide
1
Overview
5 Press the power switch on the front of the server.
The server's power LED is lit green.
When the power is turned on, the server performs Power On Self Tests (POST). If any
abnormalities are detected by POST, error messages are displayed ("9.2.2 Error Messages"
(
pg.268)).
The time to turn on the server can be set with the ASR setting (on the [Power On/Off] tab) using
ServerView supplied with this server. For details, refer to
"3.2 Settings for Server Monitoring" in
"ServerView User’s Guide".
The server's power
LED is lit green
To Next Page
Loading...
