Fujitsu PRIMERGY TX200 S2 - Page 40

40
Chapter 1 Overview
■ Inserting the CD-ROM
1 Make sure the server is turned on and press the CD-ROM eject button.
The CD-ROM tray comes out.
2 Place the CD-ROM (label side up) onto the tray.
3 Move the tray back.
Push the tray gently until it clicks into position.
 Push the center of the front panel gently until the tray clicks into position.
■ Ejecting the CD-ROM
To eject the CD-ROM, check that the CD-ROM access LED is off and then press the CD-ROM eject
button.
CD-ROM eject button
CD-ROM