FC4 / FC4 Ex (HS) connected with Mobility Server
18
GB
Putting the FC4 into operation
If your business handset has not yet been assembled
If your handset comes partly unassembled, you have to
• insert the MEM card,
• install the battery and
• remove the protective film from the display if necessary.
• Finally, your service must log in your handset to your telephone system.
Now your handset is ready for operation.
• Now connect the charger
If your business handset comes completely assembled
If your handset comes completely assembled and has been logged into
your telephone system, you only need to connect the charger.
MEM card
You can make phone calls with your handset only when a MEM card has
been inserted. The MEM card is the storage medium for important data of
your handset, for your personal settings and your personal phonebook.
When changing the handset, please remove the MEM card from your
present handset and insert it into the new handset. You can use the new
handset immediately with this MEM card.
Do not use any pointed or sharp objects for changing the MEM card!
Attention !
Observe the safety instructions for handling explosion-proof units.
To Next Page
Loading...
Need help?
General
