AP2.6 Printer
AP2-17
AP2.6 SPECIFICATIONS OF THE PRINTER
AP2.6.1 PP-510
1. GENERAL
(1) Printing System Serial Impact dot matrix
(2) Character Composition 9 x 7 dot matrix
(3) Printing Speed Draft: 200 characters/second, NLQ: 50 characters/second
(4) Emulation Epson FX850 mode or IBM Proprinter II mode
(5) Type of Characters 324 letters (Epson FX850 mode)
262 letters (IBM Proprinter II mode)
(6) Type of Paper Roll paper, type “1P”, non-carbon paper 34g/m
2
(7) Paper Holder
Maximum width 209 to 216mm
Maximum diameter 124mm
Internal diameter 25mm (winding core)
Paper end sensor Provided
(8) Paper Advance Speed 1/6, 1/8 or 1/216 inch steps, 8.3 lines/sec(at 1/6" step)
(9) Data Buffer 21K bytes (Epson FX850 mode)
9.3K bytes (IBM Proprinter II mode)
(10) Number of Copies Original plus 2 copies (Total thickness: 0.2mm or less)
(11) Ink Ribbon Original fabric ribbon (13mm x 14m)
(12) Interface Parallel interface (Centronics)
(13) Noise Less then 59 dBA
2. ENVIRONMENTAL CONDITION
(1) Operating Temperature 5°C to 35°C
(2) Operating Relative Humidity 20% to 85% (non-condensing)
3. POWER SUPPLY
(1) Power Consumption 24 VDC: 1.5 A, 36 W max.
To Next Page
Loading...
