If you display the "Switch Se-
lect" screen from the "Condi-
tion" screen, tap the title but-
ton [Switch Setting] to return
to the "Condition" screen.
80
Function
Condition
3
Tap the [Copy], The confirmation message "Are you sure" appears. To execute the copy, tap
[Yes] and to cancel copy, select [No]. When the copy destination condition name becomes
the same name as the copy source, copying is complete.
This function sets the switch to change the condition. There are two kinds of change methods
as follows.
- With one switch, change the Condition 1 and Condition 2.
- Assign a condition to each switch, and operate the switch to change the condition.
1
Tap the [Switch select] button to display a "Switch select" screen. (The "Switch select"
screen can also be displayed from the "Linkage menu" or the "User menu".)
2
Tap the switch you want to use to display the function selection screen. By selecting [Condi-
tion 1
2] from the function list, you can change Condition 1 and Condition 2 by operating
the switch. If you choose [Condition 1] to [Condition 4] for each switch, you can turn to the
condition assigned by each switch operation.
Condition change switch setting
To Next Page
Loading...
Need help?
General
