252
Chapter 13: Upgrading Your Computer
www.gateway.com
7 If you are replacing a drive, slide the old drive forward and out of the drive
bay.
- OR -
If you are adding a drive, remove the drive bay cover.
8 Set the jumpers on the drive. See the drive documentation for further
instructions.
9 Slide the new drive into the drive bay until it settles into the indentation,
then slide the release lever toward the front of the case.
10 If you removed a shipping screw, replace the screw.
11 Reconnect the drive cables using your notes from Step 5. The red-striped
edge of the data ribbon cable indicates Pin 1 and corresponds with Pin 1
on the drive (typically on the side farthest from the power supply
connection). See the drive documentation for more information.
12 Insert the left-side bezel tab into the slot on the left side of the computer
case, then swing the right side of the bezel in, towards the case, until the
right-side bezel release tab locks into place.
13 Close the case using the instructions in “Closing the case” on page 247.
8509203.book Page 252 Tuesday, July 1, 2003 7:54 PM
To Next Page
Loading...
