270
Chapter 13: Upgrading Your Computer
www.gateway.com
7 If you are replacing a drive, slide the old drive forward and out of the drive
bay.
- OR -
If you are adding a new drive, slide the drive bay cover forward and out
of the drive bay.
8 Set the jumpers on the drive. See the drive documentation for further
instructions.
9 Slide the new drive into the drive bay until it settles into the indentation,
then slide the release lever toward the front of the case.
10 Reconnect the drive cables using your notes from Step 5. The red-striped
edge of the data ribbon cable indicates Pin 1 and corresponds with Pin 1
on the drive (typically on the side farthest from the power supply
connection). See the drive documentation for further instructions.
8509203.book Page 270 Tuesday, July 1, 2003 7:54 PM
To Next Page
Loading...
